Quick Jump Menu
Info Ask a Question
Advanced Search Search the Knowledgebase
Connecting the New-Style Rotax 912 Oil Pressure Sensor to the EFIS
Author: Matt Liknaitzky Reference Number: AA-00244 Views: 11345 Created: 2012-07-11 12:08 Last Updated: 2016-03-08 13:24 0 Rating/ Voters

Attached is the manual for connecting the New-Style Rotax 912 Oil Pressure Sensor to the XTreme, Enigma, Voyager or Odyssey EFIS. This sensor is made by Honeywell.

Note: when using the RDAC XF, you do not need to install the 100 ohm resistor - you just turn the RDAC Oil P PD (pull down) dipswitch into the ON position, which connects the input to Ground via a 100 ohm resistor.




NOTE: In mid 2013 Rotax introduced new oil pressure sensor by Keller. It has the same 4-20mA output and wiring of the Honeywell sender, but is sometimes delivered without the connector terminated:
 


Pin A – Not connected
Pin B – Connected to positive bus 8 – 28 volts, use fuse or circuit breaker
Pin C – Output signal is to be connected to the instrument




Attachments
Rotax Oil Pressure Sender 20100202.pdf 0.1 Mb Download File

IMPORTANT NOTICE: You must make your own determination if the products sold by MGL Avionics are safe and effective for your intended applications. MGL Avionics makes no representations or warranties as to either the suitability of any of the products we sell as to your particular application or the compatibility of any of the products we sell with other products you may buy from us or anywhere else, and we disclaim any warranties or representations that may otherwise arise by law. Also, we offer no specific advice on how to install any of the products we sell other than passing along anything that may have been provided to us by the manufacturer or other users. If you are in need of further information or guidance, please turn to the manufacturer, FAA Advisory Circulars and guidance materials, the Experimental Aircraft Association, or other reputable sources.