Quick Jump Menu
Info Ask a Question
Advanced Search Search the Knowledgebase
iBox and iEFIS Extender Analog Inputs requiring Ground Switch to activate remote functions
Author: Matt Liknaitzky Reference Number: AA-02714 Views: 979 Created: 2019-02-13 12:45 Last Updated: 2019-02-13 12:47 0 Rating/ Voters

The iBox and iEFIS Extender Analog inputs require momentary contact with Power (12 Volts) to activate the various remote control functions available (check in Digital Inputs setup - example below). These functions are normally activated with hat switches and buttons on the control stick.

Since many joystick controls have a common Ground activation (not power), you can pull the iBox or iEFIS Extender analog inputs High (up to 12 Volts) by running 12 Volt power to each one of the analog inputs in question through an inline 4,700 ohm resistor. You can go down to a 2,200 ohm resistor if interference is expected.


This pulls the inputs to a High state, and then when you activate the Ground contact it pulls the input down to Ground and activates the function.




Full list of remote control functions is available here.


IMPORTANT NOTICE: You must make your own determination if the products sold by MGL Avionics are safe and effective for your intended applications. MGL Avionics makes no representations or warranties as to either the suitability of any of the products we sell as to your particular application or the compatibility of any of the products we sell with other products you may buy from us or anywhere else, and we disclaim any warranties or representations that may otherwise arise by law. Also, we offer no specific advice on how to install any of the products we sell other than passing along anything that may have been provided to us by the manufacturer or other users. If you are in need of further information or guidance, please turn to the manufacturer, FAA Advisory Circulars and guidance materials, the Experimental Aircraft Association, or other reputable sources.