Quick Jump Menu
Info Ask a Question
Advanced Search Search the Knowledgebase
Categories
There are no subcategories in this category.
  • Top>>
  • Single Instruments(74)
11 SP-6 In-Flight Calibration Manual

The manual for the SP-6 Magnetometer Magnetic Compass In-Flight Calibration procedure is attached. This outlines the process for updating and calibrating the SP-6 with the newer in-flight calibration software.

12 EGT Thermocouple Probe Wiring and Setup

Attached are settings and wiring connections for Exhaust Gas Temperature senders. This guide can be used to help if you are experiencing problems or if you suspect your EGTs are reading incorrectly. Remember to follow these 3 Steps first when troubleshooting…

13 CHT Thermocouple Probe Wiring and Setup

Attached are settings and wiring connections for Cylinder Head Temperature senders. This guide can be used to help if you are experiencing problems or if you suspect your CHTs are reading incorrectly. Remember to follow these 3 Steps first when troubleshooting…

14 Westach Oil Temperature Sender

Attached are settings and wiring connections for the Westach Oil Temperature Sender. This can be used to help if you are experiencing problems or if you suspect your oil temp sender is reading incorrectly. This is the oil temperature sender typically used…

15 OAT Probe Wiring

There are 2 Outside Air Temp Probes supplied by MGL Avionics. Only these Ambient Temp Probes (LM335) can be used with MGL Avionics systems. Standard OAT Probe The standard OAT probe has a red and a green wire. It is often supplied with a black sheath over…

16 Setting up the Westach Oil Temp sender as a User Sender

To setup the Westach oil temp sender as a user sender on Infinity and Velocity Singles that do not have the Westach option, you can use the following settings: You enter these points in the User|Calibrate sender menu: For Deg Fehrenheit: Points: 10 display…

17 What is the K-Factor of the FT-90 or FT-180 Fuel Flow Sensors?

The K-Factor of all FT-90 Gold Cube and FT-180 Black Cube Fuel Flow transducers is the same: (Note: MGL Avionics uses Liters K-factors for flow sensors)

18 UMA Fuel Pressure Sender Settings and Wiring

Attached are settings and wiring connections for the UMA Fuel Pressure Senders. This can be used to help if you are experiencing problems or if you suspect your fuel pressure sender is reading incorrectly. Remember to follow these 3 Steps when troubleshooting…

19 VDO Oil Pressure Sender Settings and Wiring

Attached are settings and wiring connections for the commonly-used VDO Oil Pressure Sender. This can be used to help if you are experiencing problems or if you suspect your oil pressure sender is reading incorrectly. Remember to follow these 3 Steps first…

20 MGL Compass Operation and Calibration Manual

Attached is the MGL Compass Operation and Calibration Manual


IMPORTANT NOTICE: You must make your own determination if the products sold by MGL Avionics are safe and effective for your intended applications. MGL Avionics makes no representations or warranties as to either the suitability of any of the products we sell as to your particular application or the compatibility of any of the products we sell with other products you may buy from us or anywhere else, and we disclaim any warranties or representations that may otherwise arise by law. Also, we offer no specific advice on how to install any of the products we sell other than passing along anything that may have been provided to us by the manufacturer or other users. If you are in need of further information or guidance, please turn to the manufacturer, FAA Advisory Circulars and guidance materials, the Experimental Aircraft Association, or other reputable sources.